2008 Ford F-150 Super Crew FX4

I would like to wire aftermarket accessory lighting using the stock 3- switch “message center" cluster (Part # 6l3z10d889aa) located to the right of the steering column. I want to use these switches in order to keep the stock look.

I have disassembled the switch housing and discovered it contains a circuit board with a 4-prong plug to the rear. Is there a way to use this part as a conventional switch? Can I solder wires to the prongs or should I attempt to purchase the male half of the Ford plug and splice my switches into that?

3 switches with 4 prongs to the rear? I would assume one prong in the source and the other three are the power out for each switch? dont know if I'm tring to over simlifying this.

See the attached photos to assist

http://s709.photobucket.com/albums/ww100/walker44/