rcgrant89

I put a three inch leveling kit on the fronet of my 2007 ford f150 4x4 and now it sits higher then the back can I put a 1 inch lift block on the back to level it or what height would I need to put on it to level it has anyone else had this problem?

snowborderus

Either measure the difference in height between the front and rear, that should give you your needed rear block height. Or go to a smaller leveling kit. The 3" I've heard are very hard on front end components.

rcgrant89

Yea I rebuilt the whole frond end and after I installed the lift the angle on it busted my cv joint and the front end is popping I'm thinking about going with a 2.5 inch

PerryB

I put a "2" inch level in mine and it actually ended up at 2.5

Baja Kits

For performance, I would go with a Deaver Mini pack with a 1" lift.

These are around $400

JT