Just installed some 6000k HIDs and when I turned the low beam on I noticed it was really high. I turned the high beams on and they were lower than the lower beams. So basically when I got my low beams on in my truck, the HIDs are on high beam and vice versa. What is going on with this?

 

in the instructions it should tell you something about removing a jumper set of wires. or somthing like that. i did the same for mine

 

Ok, I will have to take a look at them. The instruction manual I received was not very helpful in the install. Was very vague but I will see if it says something in there. I read online that in the light plugs, for a situation like this, you should switch the high and low beam pins?

 

I had this problem with only one side though...Someone how I managed to put the bulb in upside down.