HELP PLEASE. Stuck in 4wd.
Thread Starter
Junior Member
Joined: Nov 2012
Posts: 8
Likes: 0
From: Hamilton, MS
HELP PLEASE. Stuck in 4wd.
Here I go again with more 4wd issues. Here's where it started.
Replaced IWE. Worked well for couple of weeks.
Then it wouldn't engage into 4wd. No light on dash. Nothing.
Repaired a cracked vacuum line from IWE.
Still wouldn't go into 4wd.
Tapped on transfer case motor and heard a few clicks and now it's in 4hi.
Now for the good part.
Switch back to 2hi. Light goes out but transfer case is still engaged.
Tapped on motor again and nothing. Indicator light on dash is off, but front hubs are still engaged.
How do I get this thing back into 2hi?
Should I just replace transfer case and be done with it?
Is there a diagram out there that maps out the vacuum lines from IWE to hubs? I would love to go ahead and replace all them while I'm at it.
Thanks ahead for any and all help....
Replaced IWE. Worked well for couple of weeks.
Then it wouldn't engage into 4wd. No light on dash. Nothing.
Repaired a cracked vacuum line from IWE.
Still wouldn't go into 4wd.
Tapped on transfer case motor and heard a few clicks and now it's in 4hi.
Now for the good part.
Switch back to 2hi. Light goes out but transfer case is still engaged.
Tapped on motor again and nothing. Indicator light on dash is off, but front hubs are still engaged.
How do I get this thing back into 2hi?
Should I just replace transfer case and be done with it?
Is there a diagram out there that maps out the vacuum lines from IWE to hubs? I would love to go ahead and replace all them while I'm at it.
Thanks ahead for any and all help....
Read this thread right here. Im having some issues with my passenger side and found this thread to be very helpful. Gonna start my little project in the morning.
http://www.ford-trucks.com/forums/83...ml#post7322441
http://www.ford-trucks.com/forums/83...ml#post7322441