I am installing my intake manifold and having a hell of a time getting that little hose guessing a vacuum hose on to the manifold it's the hose on the right side looks like it goes to the power steering or something. How do I get that hose on I have spent 4+ hours maybe even more. Help thank you

 

Posting a picture would help. What does the clip on it look like?

 

One thick tab in the middle then two skinny tabs on both sides if you squeeze them them release but there is zero room behind the intake manifold

 

Is your manifold already bolted down? If not, tilt the front of it up to gain access to the port. Reach under the manifold and all the way back to pull the hose on (clip and all). Use a little lube on it and it should slide right on. If you're already bolted down, well, have fun. Also remember to route your knock sensor wires over top of the IRMC control rods (as they were).

 

It's not bolted down, I'll try that tomorrow thanks