So the guy who had my truck before me had a few fender benders on the front and back. The front one isn't as bad as the back, but I was wonderin if any of yall had any ideas on how to get those out? I'm puttin a 20" light bar in the opening below my grille and my mounts were barely able to fit. I had to hammer em in a little bit but they ended workin out fine. I've tried to hammer em out but that's just not workin too well

 

Do you have a transmission cooler behind that opening where you put the light bar? If so, that light bar is going to impede air flow to it.

 

No I don't thank goodness. I thought about that when I was putting my mounts in and there isn't one