did the Gotts mod
#13
My '08 intake tube does not look like the one in the picture. I couldn't get the 3" PVC to fit inside the hole in the fenderwell, nor could I get the coupling to fit over the intake tube. I assume you have to remove the piece that goes into the fenderwell, but I couldn't find a release tab and I didn't want to break it.
If you have pictures of this installation on an '08 5.4L, please post them or send instructions in terms that I can understand, which is real simple.
If you have pictures of this installation on an '08 5.4L, please post them or send instructions in terms that I can understand, which is real simple.
#14
Resident A-hole
Do not do this mod on the 04 and up trucks. It will make the engine run lean.
On the 04 and up trucks you have to buy a tuner to run a CAI. Even if it dosent set a CEL the trucks are lean from the factory. They run 14.5 -15 to 1 already.
On the 04 and up trucks you have to buy a tuner to run a CAI. Even if it dosent set a CEL the trucks are lean from the factory. They run 14.5 -15 to 1 already.
#15
Member
Thread Starter
Join Date: Jan 2008
Location: midwest
Posts: 359
Likes: 0
Received 0 Likes
on
0 Posts
and do I assume that you mean that for the 4.6 and 5.4? Well hell now i gotta go and undo it till I get programmer. But thanks for info.. id hate to mess up my new truck.
#17
Junior Member
Join Date: Nov 2007
Location: louisiana
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
so your saying that just by allowing a little more air, its considered a cold air intake? well i went out and did the undo process and put it back to stock snorkle tube. so what kinda tuner should i put on this that wont caust me an arm and leg but will get the job done? 2004 STX 4.6L
Last edited by doncreed; 04-03-2008 at 04:26 PM.
#19
I have the Gotts intake Mod on my 2 o7s and it DID NOT lean it out. Matter of fact i lost mpgs doing so. It gives it alot more kick in the *** though. Of course my trucks a FFV so that may make a differnce. The computers learn as you go. In order to to the mod on my 5.4 I had to cut the intake tube since it does not come apart. In order to get the 3" pvc tube to fit into the fender well you must sand it down to size. Outer circumference of pvc is 3.5" while fender well hole is 3". If what others are telling everyone is true, then a CAI will not work on these trucks either. F A L S E
#20
What about an Airaid MIT and a drop-in hi flow filter(K&N type) in the stock box? Will this cause a lean condition also? I really didn't want to buy a tuner at this time.