Built a hidden winch mount
#1
Built a hidden winch mount
This is a hidden winch mount I designed and fabricated for my 07 f150 with a 12000 lb badlands mounted to it. I havent seen any hidden winch mounts for the 04-08. I wanted something sleek, stylish and rugged without adding the weight of a full winch bumper. The factory tow hooks are still functional. Next up is installing my 6" lift, 35's and arb locker.
Last edited by tatermatt90; 03-17-2015 at 04:48 PM.
The following 2 users liked this post by tatermatt90:
hyperlogos (04-17-2021),
Randy Phelps (05-20-2022)
The following users liked this post:
Randy Phelps (05-20-2022)
#3
Senior Member
Looks good, nice and clean!
#5
Mark
iTrader: (1)
Sweet ... very clean.. you do know you could sell the crap out of those...
The following users liked this post:
Randy Phelps (05-20-2022)
#6
Senior Member
Did you fill in those spot welds? What thickness steel did you go for? It doesn't look super strong to me. But as a do it yourselfer, I generally always over build things.
Did you powder coat it? I'd like to see some more picture of it installed if you can.
Did you powder coat it? I'd like to see some more picture of it installed if you can.
#7
Senior Member
I thought the same on strength. Looks like flat bar where angle would have more strength.
Trending Topics
#9
Those tack welds were temporary in the first pictures. I went back and welded everything up after designing was finished. It's made from 1/4". I really don't have any measurements just winged it as I went along. I was going to use the existing hole in the bumper to run the line through, but the winch can't be mounted that high with my trans cooler in the way. So I made a slot in the bumper where the license plate holder was to run the fair lead mount through and the winch line. The pics dont show the underside of the mount, but the way I gusseted the winch plate I doubt it will ever bend. Truck will bend first. Lol
Thanks everyone
Thanks everyone
Last edited by tatermatt90; 03-17-2015 at 10:48 PM.
The following users liked this post:
Randy Phelps (05-20-2022)