Just put it in today. Ran it through the grommet on the firewall by the steering shaft and it came out by the pedals. Had to cut a notch in the floor fabric to feed it through. Then across to the passenger side down below the door trim to the back seat and pulled them out underneath the rear passenger side seat. Just giving y'all idea if your planning on installing a wiring kit. Back seat bolt takes care of grounding and the rcas and remote wire were run under the door trim as well. In the first picture I actually ran the wire behind the plastic by the wipers so you can't even see that either. Ran out of wire going up the rear passenger door so pit the fuse holder there (as seen in the pic) and added a small 3 foot section of blue 4 gauge to finish it off. All in all I'm pleased and think it looks good