Truxedo Lo Pro QT question
#1
Truxedo Lo Pro QT question
I just installed this cover on my 2012 Screw. I have a couple of questions. I noticed where I tightened clamps it caused the rubber seal to bulge up a little, is this normal, I didn't feel as though I over tightened. Also I have a spray in liner, where did you install the rubber seal that came with it? Does anyone have any tricks/mods they did to keep the water out that drips in the corners in the front and the small amount of water that gets in around tailgate step? The seal at front did you attach it to the rubber seal that is already attached to cover? Thanks
#2
Senior Member
I just installed this cover on my 2012 Screw. I have a couple of questions. I noticed where I tightened clamps it caused the rubber seal to bulge up a little, is this normal, I didn't feel as though I over tightened. Also I have a spray in liner, where did you install the rubber seal that came with it? Does anyone have any tricks/mods they did to keep the water out that drips in the corners in the front and the small amount of water that gets in around tailgate step? The seal at front did you attach it to the rubber seal that is already attached to cover? Thanks
Yes the rubber bulges a bit...did this on my Nissan as well but no problems. As for the weather stripping, I put it on right on the factory spray liner.
#4
Senior Member
http://products3.3m.com/catalog/us/e...er/output_html
http://www.oreillyauto.com/site/c/de...6.oap?pt=N0400
Last edited by Cleanmaxx Brian; 07-08-2013 at 11:24 AM.
The following users liked this post:
rfeltman41 (07-08-2013)
#5