Floored150

Am trying ti install my new LED for the Dome light in my 2011 Screw. I cannot find one instruction that is clear about how to remove the cover. I've seen PULL, TUG, etc., but I don't want to break it.

If anyone knows how you are supposed to remove the dome cover correctly please help. Thanks.

Floored150

Went out and didn't care if I broke it. Grabbed front lip of cover (side facing front of truck) put my finger on left side of lip and pulled down on lip. It flew off and scared the crap out of me. Also got a charlie horse at same time. Replaced LED. Did not work. Pulled it out, turned it 180 degrees and it works. It works one way only.

As for the map lights, to remove cover....... Open sunglass tray. Grab top lip of map light cover on inside (towards sunglass tray, do this on both sides at one time) Pull down on lips at same time. They start to come out, then keep pulling entire cover down and towards rear of teuck.

Thats how I got them, off. As for putting them back on the dome just pressed right on. The maps too.

tireur

Hi, I did the samee thing as "floored150", except no chalie horse...

Toddman38

iTrader: (5)

I used a plastic trim pry tool, popped right off!

UFLBret

Pics or it didn't happen....

apeman88

Had a hard time replacing my bulbs as well.... this helped.


Ken

DylMyr

Yup... thought I was going to rip the entire housing out of the roof panel when I took mine off.

STingray1300

The investment in a set of trim removal tools will pay for themselves in no time - trust me (mine is a pro set - $25.00, but they can be found on fleaBay for as little as $10

Floored150

Ill note that, good idea thanks!

Floored150

Lol, the only pics i took were of the broken reverse led. I was too stressed and pissed during the install. Geez, light bulbs and I had a hard time. Unbelievable.