mirror reflectors changed to turn signals
#561
Senior Member
I tried doing mine through the puddle lamp cap, but I think my wires are too short. So I tried popping my mirror glass off and wire it up that way but I can't get the stupid mirror glass off lol. I tried using a flathead screw driver and prying on that special spot, but man them ***** aren't coming off lol.
#563
Village Sociopath
iTrader: (1)
Join Date: Jun 2014
Location: Nowhereville Barton City Michigan
Posts: 28,528
Received 10,073 Likes
on
6,507 Posts
When I did mine, I RTVed the back of the strip, and soldered and used liquid electrical tape on the splice.
The following users liked this post:
Waterfowler41 (03-14-2015)
#564
Senior Member
The following users liked this post:
Waterfowler41 (03-14-2015)
#566
Senior Member
I used white
#567
F150 Greenhorn
I used white. Both look fine. Amber probably would match the turn signal better.
#570
Senior Member
iTrader: (1)
Well I opted against the DRL upgrade and went blinkers only but I split the LED strips and did two 9 LED strips on both sides. I wish there was a batter way to get through the door jam. I used Amber leds.
I noticed not many people do this so one word of advise, try to trim as much of the reflector backing as you can, it will leave you just enough room for the two led rows.
Overall very happy, took 2 hours on my driver's side since I was still fine tuning my approach then the passenger side only took 30 minutes. I used butt connectors loaded with dielectric grease and shrink wrap over the top.
Sort of pissed my wife is taking my truck shopping tonight so unfortunately I won't seem the rewards of my work until later tonight.
Doing my dad's platinum tomorrow.
I noticed not many people do this so one word of advise, try to trim as much of the reflector backing as you can, it will leave you just enough room for the two led rows.
Overall very happy, took 2 hours on my driver's side since I was still fine tuning my approach then the passenger side only took 30 minutes. I used butt connectors loaded with dielectric grease and shrink wrap over the top.
Sort of pissed my wife is taking my truck shopping tonight so unfortunately I won't seem the rewards of my work until later tonight.
Doing my dad's platinum tomorrow.
The following users liked this post:
GotHonks? (04-03-2015)