Made an appearance modification to my tailgate.
#31
Senior Member
Originally Posted by WrestlingCoach
If you want to remove items that use the 3M tape like badges simply take a piece of fishing line and hold both ends while putting the line next to the badge and surface of your vehicle. Pull the line tight back and forth and it will begin to "saw" its way through the tape and release the badge from your vehicle. Then clean up the rest of the tape attached to the vehicle. This can be safer than prying or using heat guns against your vehicle.
This could have been my best idea for this mod so far.
Dennis
This could have been my best idea for this mod so far.
Dennis
#32
Senior Member
Thread Starter
#33
BAMF Club
Originally Posted by ford5.0tx
im putting 5.0 badges on the sides of mine were the ecoboost and 6.2l badges are this weekend. i will post pics
*SLEEPER!*
#34
Senior Member
Thread Starter
Dennis
#35
ℳℴↁ℮ℜ@大☢®
I agree though
5.0
SVT
I'd even strip the "High Performance" badge off... because, well, it's not... it's a stock truck motor, and until you invest a few bones in some major upgrades, there's nothing "high performance" about it to be honest, no matter what the dyno numbers say.
I'm have plans to put a 4.6l 3V badge in the same spot on my 2010. Down the road I plan on installing Ford Racing cams, underdrive pulley setup, getting it professionally dyno tuned, and MAYBE, if money permits, a SC. Then once all that's done, MAYBE, I'll put a "High Performance" badge like that under the 4.6l badge... MAYBE... I dunno, because I don't want too be tacky about it...
#36
#37
#39
#40