LED help
#1
Proud XL owner
Thread Starter
LED help
I'm sorry if this is on here already but I've been searching for a while and haven't found my answer.
I installed LEDs on my driver side today because I'm still waiting on the bulbs for the passenger side. Wired up all the resistors and everything seems good. When I have the power on but not the engine they work fine. But as soon as I start the engine, they move to hyper flash. The hazards work fine but engine on blinkers = hyper flash.
I installed LEDs on my driver side today because I'm still waiting on the bulbs for the passenger side. Wired up all the resistors and everything seems good. When I have the power on but not the engine they work fine. But as soon as I start the engine, they move to hyper flash. The hazards work fine but engine on blinkers = hyper flash.
#3
F150 Forum
You have two six ohm load resistors on the front and back correct? (4 resistors total). They need to be paralleled to the signal and ground. Any pictures of your install?
#4
Proud XL owner
Thread Starter
Originally Posted by tuxedoblack11
You have two six ohm load resistors on the front and back correct? (4 resistors total). They need to be paralleled to the signal and ground. Any pictures of your install?
Haha I'll have to get a picture but I drew you one until I can too see if it would help, probably not
#7
F150 Forum
Everything looks to be in order, I'd check the wire taps and make sure you have pierced the plastic on the wire and are making connection. Use a pliers to clamp those metal stabs onto the wires. Then check with your test light or meter to see if you have connection.