Fuel readings off
I filled the truck up a week ago and put 330 miles on it. My gas gauge read a little under 1/4 tank and miles to empty was 50. I go to fill up and I was only able to fit 20 gallons in the tank before the pump was saying my tank was stuffed. I know, for a fact, that I have roughly a 30 gal tank since I have put in close to 30 gallons before. Is this a fuel pressure/sending unit issue? Do I have a funky fuel gauge?
I do not seem to be getting even ballpark reading from fuel gauge or miles to E.
2010 FX4 SCrew 103k miles
I tried searching on these forums as well as anything else I could find but have not found a similar issue. Although it could be due to brain fry from all this darn OT at work.
Back story:
62 mile commute to work on highway and filled up before leaving for work. I get roughly half way and I am now at 1/4 tank gas and could watch the gauge moving towards E. I stopped at a gas station and put $25 worth of gas in and the truck would crank but not start. After 30-40 minutes of sitting and trying to start it, it finally started and I made it to work without another fuel issue. I replaced the evap canister purge valve behind the throttle body and cleaned the O2 sensors. Since I did that, I have not had a stalling-after-filling issue or any other issue.
I do not seem to be getting even ballpark reading from fuel gauge or miles to E.
2010 FX4 SCrew 103k miles
I tried searching on these forums as well as anything else I could find but have not found a similar issue. Although it could be due to brain fry from all this darn OT at work.
Back story:
62 mile commute to work on highway and filled up before leaving for work. I get roughly half way and I am now at 1/4 tank gas and could watch the gauge moving towards E. I stopped at a gas station and put $25 worth of gas in and the truck would crank but not start. After 30-40 minutes of sitting and trying to start it, it finally started and I made it to work without another fuel issue. I replaced the evap canister purge valve behind the throttle body and cleaned the O2 sensors. Since I did that, I have not had a stalling-after-filling issue or any other issue.








