Ford raptor off road mode button help
#1
Triton
Thread Starter
Ford raptor off road mode button help
So I've installed the raptor upfitter switch assembly and wanted to use the off road mode button for something but I'm not sure what wire goes to what. I know there is two ground wires and I've figured out what wire lights up the lettering but there's three more wires left that I'm u sure of. Anyone used this before? Have the diagram/schematic? I've searched the forum for days looking but only the schematic for the upfitter switches is posted.
#5
Triton
Thread Starter
#6
Ford raptor off road mode button help
Yes. You will need some logic to have it a light stay on after you release the button and it's a ground switch and not designed for loads. I would not run any high load light on it
#7
Triton
Thread Starter
Trending Topics
The following users liked this post:
sigma pi (11-05-2015)
#9
i know this is an older thread but any one ever see a pin out of the switch its self i know this post labels the wires but which pin is which on the switch? also any one know a part number for a connector or pigtail for the button?