tko_818

iTrader: (1)

standfast85

This is how I received the frame.




This is the setup I used to mount it to the bumper. I drilled a 1/4 hole right above the existing holes for the license plate. Worked perfectly and the nut adds a bit more peace of mine.




Installed




Wired up




Back view




I was done so quickly with the installation I had time to wash, clay, and wax my wife's Escape. Win!

tko_818

iTrader: (1)

Cheap reverse lighting upgrade, and a job well done on a detail.. throw in a cold one and thats all sorts of win

standfast85

twhat159

How did yall run the wires to your reverse lights?

2008f1504x4

Mine will be here tomorrow or Wednesday ... Unfortunately ill be waiting on my brand new truck to get out of the body shop to install... Should get truck back Friday...

tko_818

iTrader: (1)

If u look under the truck, you will see the wire harness running up into the bed to the tail light between the spare tire and your rear bumper.. i just zip tied the License light wire to the harness, fed it up into the tail light area with clothes hanger, and tapped into the reverse light wire!

standfast85

Real simple: just find the black tubing that contains your taillight wires. If you lay under your truck underneath the hitch the tubing will come out from where your tail lights are. Follow the tubing up to the rear of your taillight and find the reverse bulb. There are two wires coming off of it, I think the blue wire was positive. Splice, electrical tape, zip ties and voila.

gm125800

Too late. Out of stock already. I should have seen this earlier.

standfast85

Forgot to mention: I checked every inch of my frame and I found 0 defects.