those of you with airlift bags, where did you mount your compressor, thanks

 

subscribed

 

Under the hood

 

In the garage. It's too big to mount to the truck unless I mount it in the bed

Actually, I just ran the two lines together and like someone else on the forum I put the fill valve in the behind the gas filler door. Works like a charm

I only use the bags for towing so I just fill them to 50 psi before hooking up the trailer and then release the air until I get the height I want on the back of the truck.

I do have a small portable compressor I picked up from Harbor Freight that I keep under the rear seat in the little compartment the gas funnel is located in for when I want to fill up on the road. Only takes a couple of minutes.

BTW, I ran all of my air tubing inside of this worked out great and protects the tubing from rubbing and potentially wearing/leaking.

 

not for air lift but same concept. you can see mine mounted behind the drivers side tire mounted to the bed

 

Mine was installed on the passenger rear, on the inside of the frame.

 

Passenger rear inside frame rail. Hadi it to do over wound mount above spare tire.

 

I have a SCAB and mine is mounted under the rear seat behind the driver, next to the emergency jack and the toggles to operate it are mounted in the center console.

 

Mine is mounted above my spare tire.

 

mine is mounted to the frame, passenger side between frame and body