2010 XLT bambi mode
#1
Expert main pipe
Thread Starter
2010 XLT bambi mode
I know this might have been written up before but I looked everywhere and I could not find how to do bambi mode on a 2010 XLT with ForScan. I tried another write up for a 2013 but it did not work. I tried looking through the ForScan tweaks thread and could not find it either. Does anyone know how to program bambi mode on a 2010?
This is what I tried and did not work:BLOCK 726-11-01 CHANGED THE FORTH DIGIT OF THE FIRST SET OF NUMBERS TO A 2 INSTEAD OF 1.
This is what I tried and did not work:BLOCK 726-11-01 CHANGED THE FORTH DIGIT OF THE FIRST SET OF NUMBERS TO A 2 INSTEAD OF 1.
#2
Senior Member
I know this might have been written up before but I looked everywhere and I could not find how to do bambi mode on a 2010 XLT with ForScan. I tried another write up for a 2013 but it did not work. I tried looking through the ForScan tweaks thread and could not find it either. Does anyone know how to program bambi mode on a 2010?
This is what I tried and did not work:BLOCK 726-11-01 CHANGED THE FORTH DIGIT OF THE FIRST SET OF NUMBERS TO A 2 INSTEAD OF 1.
This is what I tried and did not work:BLOCK 726-11-01 CHANGED THE FORTH DIGIT OF THE FIRST SET OF NUMBERS TO A 2 INSTEAD OF 1.
The following users liked this post:
Gale Hawkins (01-01-2019)
#3
Expert main pipe
Thread Starter
I hope someone here has done it before. I’m going to wait a little and if I don’t get help I will play with it to see if I can find the right combination.
#6
How's she goin' eh?
The forscan thread at the top of this page would probably have a better answer than here. Unfortunately 2 things. 1. You will have to search. 2. Like mentioned there is very little avail for trucks previous to 2011 because of the switch from GEM to BCM.