I’ve done a lot of research on the leveling kit page and on custom offsets gallery and over the web but still trying to get confirmation. Im trying to run the setup below. The details of my truck are below as well. I just want to know if the setup will work for my truck without rubbing and if it will rub....rub possibly what and what solutions are there for crash bars fenders etc. Please help new member here as well. Heard good things about this forum which i chose over others. Thanks for your help in advance fellas!

setup wanted to run: 20x10” fuel assault -18 offset with 33”x12.5”x20” nitto ridge grapplers.

truck setup currently: 2018 XLT 2WD sport version Screw all stock except for a 2.5” leveling kit from autospring (offset)

You will have to trim with that setup. May be able to get away with spreading the crash bars some.

thanks fellas! I’m thinking to dropping possibly now to 295/55/20 hoping this setup will work without rubbing or trimming and if not then just spreading the crash bars a little at worst. I saw people say the 33x12.5 could be done with minor rubbing at full lock and other say major trimming on metal and plastic. So o don’t feel like I can believe one or the other. Same with the 295/55....wish someone knew for sure at least in the 295/55 measurement and if there is any issues with that setup if any

yes I outbit would be a -18mm offset. Just wanted to confirm with others. I’ve seen some say they’ve done it without trimming and others say they have had to trim and the other people saying they didn’t are lying. With a leveling kit only of course. I’ve looked on the thread for leveling kit but and we t though all and only a couple had siniliar setup but didn’t say specifically what they did. They fit as far as getting them on but the rubbing they don’t say and I’ve posted a reply and no answer back