JSS829

Just like the title states, I'm looking to get signal and power the LC2i from the factory C-pillar harness. Am I thinking about this correctly? Speaker level, 12v etc in to the LC and then RCA to the amp?

Can anyone confirm if this will work?

The set up I'm looking at is the Cerwin Vega VPAS12 getting signal from the LC2i

earsmccoy

I was trying to do something similar this weekend. I wanted to use the remote on terminal from that harness to turn on my amps. Even with enabling the subwoofer through Forescan I couldn't get the remote turn on to work on that harness. That being said, The 12v terminal was hot all the time so I think, in your case, it would absolutely work. It is either the top left or top right terminal. On a side note, is there a reason that you are using the LC2 instead of just converting the speaker wires to "low level output" and going strait to your amps? That is what I did this weekend and it was definitely the better set up (for me).

Wyo11Scab

iTrader: (1)

Where are you putting the LC2? I always get signal wires from the door sill