Vent Visors, your favorite?
#11
Senior Member
A set of AVS vent visors. In channel snap fit no glue strips at all.
I can't find them on the website but are held by tabs at the ends. They do interfere a bit with electric auto window closing, a need to be jogged the last 1/2 inch into full closed. No rattles, never slipped in place, seal very well. KM
I can't find them on the website but are held by tabs at the ends. They do interfere a bit with electric auto window closing, a need to be jogged the last 1/2 inch into full closed. No rattles, never slipped in place, seal very well. KM
I'm glad I looked as this thread as I was going to order the Weather Tech as I thought they were the only place tgat offered the in channel window vents. The AVS are almost 1/2 the price.
Last edited by Promodmerc; 06-13-2020 at 12:39 PM.
The following 2 users liked this post by Promodmerc:
2017bluetruck (06-13-2020),
Iphylgood (02-12-2021)
#12
Senior Member
AVS Low Profile here as well. No complaints and they look awesome.
The following 2 users liked this post by mcr1911:
Iphylgood (02-12-2021),
thefreeauction (05-07-2021)
#13
Old Fart
I have Lund in Channel on mine, finally got around to putting them on yesterday.
#14
Senior Member
WeatherTech WeatherFlectors™ Dark Tint
.
.
.
The following users liked this post:
12-VoltMan (07-02-2020)
#15
I was hoping mine wouldn't bind up like that.. After letting mine sit over night, all windows work normally except front passenger. It would bind like yours and rebound and open again. But this morning I checked (about 40 hours since install) and auto up works without binding now.
#16
Senior Member
I was hoping mine wouldn't bind up like that.. After letting mine sit over night, all windows work normally except front passenger. It would bind like yours and rebound and open again. But this morning I checked (about 40 hours since install) and auto up works without binding now.
#17
music man
My 2015 Platty with low profile stick on. I could never get the in channel to work properly.
#18
Senior Member
WT in channel for me. If I leave the window(s) down lower than the visor itself for several hours, mine will bind up a bit or bounce back when closing but not a big issue for me. I can do it manually and the window will close with no real issues.
#19
Senior Member
I did have a set of WeatherTech vents in for 2018. I live in WI and we had a spell of -20 F cold that cracked the lips of the visors. Could have been a bad run, they were in channel with an adhesive strip. KM
#20
I had weathertech in channels. They ended up in the trash - would interfere with the automatic up on the window randomly, and after removing, it left a permanent indentation in the weather stripping. I'll probably get some of the avs low profile stick-ons in the future.
The following users liked this post:
Iphylgood (02-12-2021)