Topic Sponsor
General F150 Discussion General Ford F150 truck discussions and questions
Sponsored by:
Sponsored by: Real Truck

tranny wont shift

Thread Tools
 
Search this Thread
 
Old Jul 3, 2009 | 04:05 PM
  #1  
302 efi's Avatar
Thread Starter
Junior Member
 
Joined: Jun 2009
Posts: 18
Likes: 0
Default tranny wont shift

Hi ive got a 1987 f-150 302 i swapped to a 1994 351 the tranny is an overdrive it runs good but just wont shift out of first. it seems like it gets to the point were it should shift and then acts like its slipping. any ideas????
Reply
Old Jul 3, 2009 | 08:54 PM
  #2  
Kattumaram's Avatar
Retired Aerospace
 
Joined: Dec 2008
Posts: 1,324
Likes: 14
From: Edgewater, Florida
Default Swapped What?

Is the tranny from the '87 or the '94?
Reply
Old Jul 3, 2009 | 10:37 PM
  #3  
ATOM's Avatar
Senior Member
 
Joined: May 2009
Posts: 2,959
Likes: 5
Default

isn't that trans computer controlled..
Reply
Old Jul 4, 2009 | 12:07 AM
  #4  
302 efi's Avatar
Thread Starter
Junior Member
 
Joined: Jun 2009
Posts: 18
Likes: 0
Default

Trans is from the 87, yes i think its computer controlled. It feels like it goes into second then nothing is there. you can flutter the throttle and it feels like neutral then it'll all a sudden pop back into first.
Reply
Old Jul 4, 2009 | 08:57 AM
  #5  
Kattumaram's Avatar
Retired Aerospace
 
Joined: Dec 2008
Posts: 1,324
Likes: 14
From: Edgewater, Florida
Default One or the Other:

The tran is either an E40D or an AOD....the AOD is not computer-controlled; the E40D is. Why either transmission is not working correctly with the engine change is a mystery to me....if all the sensors used on the 302 were transferred to the 351.

If the trans is the AOD, then the throttle position settings may have been messed up, and those settings must be right or the tran could suffer an early death.

FYI: The E40D will have a MLP sensor and harness/connector mounted on the shifter shaft lever. The AOD has just a rod or cable connected to the shifter shaft lever; there is no kick-down lever.

To unhook the tran control, if an E40D, from the truck system go here and invest in a TCS and harness:

http://www.becontrols.com/products/electronicscat.htm

It's not cheap, but it gives you complete control of the tran with no interference from the truck electronics.

Last edited by Kattumaram; Jul 4, 2009 at 09:36 AM.
Reply




All times are GMT -4. The time now is 04:42 AM.