Nerf board/running board question
 

Good Morning All,

I have a 2010 F150 XLT with the original factory nerf bars. I was given the new style running boards off of a 2015 F150. The mounts are a little different (see attached pic) ... but I would like to make them work somehow. Has anyone had any luck putting the new style running boards onto a 2010 F150? Thank you.

I just put 2015 boards on my 2011. You are correct, the new mounts are different.

I used the original mounts and trimmed them back 3/4 inch. I put the new boards on the old mounts, lined up where I wanted them, marked them and drilled new holes.

I think they came out pretty good.


https://cimg3.ibsrv.net/gimg/www.f15...e25001df83.jpg

https://cimg4.ibsrv.net/gimg/www.f15...af7dc85097.jpg

^^Nice job!:thumbsup:

That looks really good. I wish you lived in Michigan so you could help me out, Ha. Did you have any issues removing the new mounts from the new boards? I basically had to snap/cut the old bolts on the old boards because they would just spin... between the lock tight and the rust they weren't coming off.

Thank You.

No, All the bolts unscrewed nicely. I was fortunate and found a set that were removed almost right away.

..