When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I have a 2010 F150 XLT with the original factory nerf bars. I was given the new style running boards off of a 2015 F150. The mounts are a little different (see attached pic) ... but I would like to make them work somehow. Has anyone had any luck putting the new style running boards onto a 2010 F150? Thank you.
I just put 2015 boards on my 2011. You are correct, the new mounts are different.
I used the original mounts and trimmed them back 3/4 inch. I put the new boards on the old mounts, lined up where I wanted them, marked them and drilled new holes.
That looks really good. I wish you lived in Michigan so you could help me out, Ha. Did you have any issues removing the new mounts from the new boards? I basically had to snap/cut the old bolts on the old boards because they would just spin... between the lock tight and the rust they weren't coming off.
That looks really good. I wish you lived in Michigan so you could help me out, Ha. Did you have any issues removing the new mounts from the new boards? I basically had to snap/cut the old bolts on the old boards because they would just spin... between the lock tight and the rust they weren't coming off.
No, All the bolts unscrewed nicely. I was fortunate and found a set that were removed almost right away.
10-18-2017, 11:47 AM
Nerf board/running board question
