JLindsay32

I have the pioneer 4100DVD H/U, i've had it for a few weeks, but never wired in the factory sub. I didn't have the connecter to wire it. Well today I got the audiophile connecter that receives the stock wiring plug and converts it to the Red and White plugs to plug in to the H/U. There are also two blue wires coming off the back of the connector. I just plugged everything up, other than the two blue wires, and the sub is still not firing. I have it turned on and up through the H/U, but it's still not firing. Does anybody know if these two blue wires are necessary and if so where they go??

2010FX4F150GILROY

They should be amp turn on for aftermarket amps... I did not realize anyone had an adapter to work for the sony nav units yet...
Maybe tell the part number you recieved I can or someone else can be of more help...

JLindsay32

Here are some pics... I hate wiring! haha
Plug Connector

Plugged in to respectable ports...

dos0711

Blue wires are the turn on signal to sub

2010FX4F150GILROY

I need to know the name and part number of the wiring harness you have installed...

dos0711

Check out this thread too...

https://www.f150forum.com/f30/factory-sub-nav-8200/

.

JLindsay32

So looking at this, do I just need to cut the Dark/Green/Violet wire and wire one or both of the wires to that??
Dark/green/Violet- sub amp enable
Black/orange - ground
Violet/light blue - voltage supplies at all times (overload protected)
Brown/orange - subwoofer signal +
Red/Black - subwoofer signal -
Black - shield

dos0711

I'm lost...the two wires shown just attach to the radios antenna power lead and your amp should turn on. After you confirm it's working, read the thread above.

JLindsay32

The two blue wires are the ones i'm referring to, I'm not sure what if anything to connect them to. They say AMP TURN-ON. This was an extra one the install guy had so I don't have any of the supplied directions etc..

dos0711

Connect it to the antenna power lead coming out of the Pioneer