Lift spindles and new rotors now abs rubbing on ring
#1
Lift spindles and new rotors now abs rubbing on ring
New to the site.also new to f150's.i just bought a 01 f150 Supercrew 2wd.just did a lift spindle along with new upper and lower control arms new ball joints,tie rods,wheel bearings,pads and rotors.now for my question,now that I have done all this my abs sensor is rubbing on the abs ring that's pressed on the rotor.just wondering if anyone has had this issue before and knows of a fix.tried searching but haven't found much.i was thinking of opening the hole that the sensor goes into on the spindle so I can move it up a bit to clear the ring.sand the ring down some.let me know if you guys can help.thanks in advanced.
,
,
#2
Member
IIRC shimming the sensor away from the ring would be best. apparently the new spindles were machined wrong.
.
.
#5
Member
There is no shim, you have to make one using a flat washer.
.
.