Originally Posted by Austin97

Check the switch on the other door. If it doesn't work either check fuse 8 in the battery junction box (fuse box under the hood). If that's good pop the switch panels out and check for power at the switches. If they have power and still don't work ohm the black ground wire with any body ground or the negative battery terminal. If you have done all that, have power and ground, watch the door lock rod tip that sticks out the top of the door panel. If it twitches when you hit the lock or unlock switch you have bad actuators. If they don't twitch pop off the door panel. Locate the door lock actuator connector and unplug it. put a paper clip in the ground end of your test light and stick it in one side of the connector and put the light end of in on the other wire. Hit the switch and if the light lights up you have a bad actuator. If there is no power your switch or the wires between the switch and actuator is bad. Look for the same color wires that you just tested at the actuator and find them coming out of the switch. Test them the same as you did at the actuator. NOW FINALLY if you have power coming out of the switch to the actuator, but no power at the actuator you have a wiring problem. If there is no power coming out of the switch you have a bad switch. It's really a pretty easy diagnosis if you go step by step. Hopefully you figure it out in less time than it took me to type this.

Originally Posted by 2000MTZ

^^^ thats a perfect reply,(i think, got bored halfway through reading it)
I would bet its your actuator, mine went bad and it wouldnt lock or unlock when pressing the button on the door, or the outside keypad

Does the passenger side unlock when you press the button? if it does then its your actuator thats bad

Originally Posted by Austin97

You think you were bored reading it, try writing an absurdly unnecessarily detailed post. I should have done it in steps to make it easier to read.


Since you don't have time to mess with my nonsense post:
If the rod tips move or it unlocks from hitting unlock over and over it's actuators.
If one switch works both doors and one doesn't its the switch.
If one door locks and unlocks and one door doesn't, it's the actuator.
If neither switch does anything check fuse 8 under the hood.

Originally Posted by brandonjr36

no it dont unlock it just twitchs to get it to unlock you have to pull the handle

Originally Posted by Austin97

You think you were bored reading it, try writing an absurdly unnecessarily detailed post. I should have done it in steps to make it easier to read.


Since you don't have time to mess with my nonsense post:
If the rod tips move or it unlocks from hitting unlock over and over it's actuators.
If one switch works both doors and one doesn't its the switch.
If one door locks and unlocks and one door doesn't, it's the actuator.
If neither switch does anything check fuse 8 under the hood.

Originally Posted by 2000MTZ

So both the driver and passenger side doors wont unlock electronically?

Originally Posted by 2000MTZ

its the actuator,
Mine came from ebay and i think it was around $20-30, dont remember though its been a while

Originally Posted by 2000MTZ

its the actuator,
Mine came from ebay and i think it was around $20-30, dont remember though its been a while