is there any way to adjust the bounce back on the one touch window mine keep returning to down position i do have forscan

 

It's in the manual somewhere...I had to fix mine a while back...

I think you have to put the window all the way up and Hold the button. Then One touch the button all the way down and hold it again. Then once more back up and hold?

 

Roll the window all the way up. You may have to bump it up little at a time to get it rolled up without it going back down. Then hold the switch up for 2 seconds. Then release and hold it up 2 seconds again.

I have had to do this two or three times on my '22

 

That's it, lol. Thank you for clarifying better than I did.

 

rolling the window all the way up and holding is to active the one touch the one touch is activated but when using it, the window just reaches the top and bounce back down the sensitivity needs to be adjusted so it will stay up. trying to find if the sensitivity can be adjusted, it gets agrivating when you have to roll the window up 3 or 4 times

 

The former posts are giving good info. The switches have a bump and all up. Bump is just a very light lift on the switch all up is just a very slight touch more.

My 22 has very sensitive switches and one needs to get the right feel to stop from over pulling on on the switch to just bump it.

With old beat up arthritic fingers it sometimes can be !!! and some choice words are used to refer to the system and Ford Engineering and to have a simple hank cranked window.

 

My 2023 f150 just started doing the same thing yesterday! I appreciate the tip on how to correct the issue! Thanks