Looking for anyone that has leveled their 2024 F150 Tremor. I am looking at using the Motofab 2.5” front leveling kit but want to make sure I dont end up with reverse rake. Anyone used a 2.5”?

 

2.5 will be pressing it. That the max recommended to prevent premature wear. 2” is what I bought. It will has a little rake.

 

What gives the Tremor its lift in the front ? Is it the shocks/sorings ?
because I’ve seen guys completely change out to 6112 or something else vs a puck spacer. I’d imagine 2.5 is sag test you want to go and with tremors 2.5 rear block getting it to level may be difficult unless you go to 3inch in front which many guys will tell you it’s not good for the other joints

 

It's a Tremor I would leave it alone...

 

Bought a new '25 Tremor last week and asked the dealer about leveling it. They use a local shop that suggests the ReadyLift 3" Tremor leveling kit. It's a pre-load kit that also replaces the UCA's to help with ball joint angles. Anyone have any experience with this?

ReadyLift 3" Tremor Leveling Kit