For you guys who have been through this installation before, I need a little help on what should be a very simple step. I am the point of placing the Whipple intake onto the engine and there is a pre-made rear fuel cross over hose, and I remember someone made a comment that there is a protective sleeve and heat shrink for this hose. I found the bag in the Whipple parts, but…. The sleeve is only 1” wide – so, how do you get this sleeve over the pre-made fittings on both ends?

Or this this sleeve for somewhere else? I read through all steps and I don’t’ see anywhere else this Sleeve is to be used..

 

Never mind I figured it out – I knew it was a simple question. If you look at it long enough and throw a couple of cuss words at it - the answer will appear. At least for me.

 

 

Yes, never used that type of Sleeve before. The install is easier that I anticipated (so far). Hoping to get the super charger in the truck tomorrow.
Thanks for the help.