Yet another RABS question
#21
Member
#22
#23
Member
Scroll back and make sure the wire connector and color of wires match.
Sounds like it.
If it is the rabs module this is the first harness test, you may need to make a long jumper wire to span the distance because most dvom leads aren't long enough. Disconnect the module and the rabs valve from the harness.
.
Sounds like it.
If it is the rabs module this is the first harness test, you may need to make a long jumper wire to span the distance because most dvom leads aren't long enough. Disconnect the module and the rabs valve from the harness.
.
Last edited by RLXXI; 08-30-2013 at 06:44 PM.
#24
Scroll back and make sure the wire connector and color of wires match.
Sounds like it.
If it is the rabs module this is the first harness test, you may need to make a long jumper wire to span the distance because most dvom leads aren't long enough. Disconnect the module and the rabs valve from the harness.
.
Sounds like it.
If it is the rabs module this is the first harness test, you may need to make a long jumper wire to span the distance because most dvom leads aren't long enough. Disconnect the module and the rabs valve from the harness.
.
#25
Member
#27
Member
#29
Member
#30
Resistance was infinite, no change, so I guess it's replace the electronic module. Is there a test of the module to verify it's bad bfore I pony up the dough to buy a new one?
Also can just the float sensor be replaced or does it only come with the reservoir as an assembly. Or, does the reservoir come with the sensor but only as an assembly with the master cyl?
Last edited by Jinark; 08-31-2013 at 06:24 PM.