I hope this is where I should post this question my apologies if not.

I have a 1986 Ford F-150 truck, In-line 6 cylinder with manual trans. with shift on floor. I am attempting to replace the ignition switch but I am stuck at the onset. I have a set of procedures for replacing the switch but I cannot determine how to remove the shroud that is covering the switch. I have remove the lower shroud, but the middle one does not seem to have any screws and I don't want to break it by attempting to just pry it off the column unless that is the method that will have to be used. Any advice would be appreciated.

Thanks,
Garry