I would like to share my simple to make bed divider/fence with other F150 owners. It is made from 2-12" pieces of 2x4 and 2- 5'+ pieces of 1x4 common lumber. It fits across the bed between any one of the 4 vertical ribs in the bead sides located between the tail gate and rear wheel wells.The four fence pieces are easily installed or removed by hand. No tools required. My truck is a 2017 F150.
I don't know if all the late models have the stiffning ribs in the sides of the bed or if its only those with the aluminum bed.
I will try to add photos and files to this post. Haven't done this before. Wish me luck.

 

 

I totally agree.
Could you tell me how to get photos into my post? I was able to upload from my computer to my album in the forum however haven't been able to figure out how to get the photos from my album to my post
Thank you

 

Here are photos missing from original post

 

I like it. Good job

 

Looks great! On my '14 there is only 1 spot for the divider to fit, I just used a 2x8 that I rounded the lower corners on. I also added a hinged 'wing' to hold my Action Packer from moving left to right. I stained it because I was bored. Had it in there for 2+ years now. Works great!

 

Before retiring I worked in warehousing. At some point I was able to grab one of these load locker bars. Been hauling it around in our moves for about 15 years. When I bought this '04 Lariat I finally got around to using it. Cut the bar so it fits my bed and WAA LAA! No more crawling up in the bed to retrieve something that has slid forward !