Who's Done Trans Fluid Change
#21
First time caller..
Changed fluid, filter, and gasket in mine at 70k mi, in my garage, checked the level with the dipstick, temperature with infrared thermometer....works like a charm.
What does the computer tell you?
Changed fluid, filter, and gasket in mine at 70k mi, in my garage, checked the level with the dipstick, temperature with infrared thermometer....works like a charm.
What does the computer tell you?
#22
This 15 looks like it's going to be a lot bigger pain in the *** to do compared to my last F150 (2004 year). Who has done it? How'd you go? Pan drop or run through the cooler lines? How rough is filling it back up with no dipstick? Does it take Mercon LV?
I was looking for a How To but didn't find anything on 15 or newer.
I was looking for a How To but didn't find anything on 15 or newer.
#24
Senior Member
I just did mine in the driveway. My 2016 6r80 has 45000 miles. I just dropped the pan, bolted on an aftermarket pan on with a drain plug and filled her back up. Took a tad over 6 quarts. It's a simple procedure but a PIA at the same time cause the filter keeps falling out while I'm trying to put the pan back on. Plus the dip stick/fill hole is next to the cat and you have to fill it while the engine is running and the fluid is 195-215 degrees. Get some gloves. I plan on draining and filling every 30,000 or so and changing the filter every other time. Not gonna bother with flushes.
Last edited by madmatt83; 10-18-2019 at 05:13 PM.
#25
Dielectrically 5w30
Refill amount with the default pan would be useful, i see the instructions state 3.5qts for the initial fill to get up to temp.
#26
Senior Member
When I pulled my engine I changed the tranny fluid since I lost some fluid from the cooler and lines. I have a Motive power fill that works great for diffs, transfer cases, and transmissions without fill tubes. The end is hooked and sits in the fill hole perfectly. This is what it looks like:
#27
Thanks tmcolegr for posting this information!
I do have a couple of additional questions regarding this topic, if you have time to respond.
I do have a couple of additional questions regarding this topic, if you have time to respond.
- Do these documents apply to the 2018 3.3L V6, with a 6R80 transmission? (I did not see the 3.3L referenced in the documents)
- What is the correct part number or model number of transmission fluid filter for the 2018 6R80? I have seen two part numbers out there, so I'm uncertain which to buy ... (FT188 or FT200)?
- What is the correct part number for the 6R80 transmission pan gasket?
#28
Ford ATF Chart by Vehicle and Transmission
Hey Fellow Owners',
I stumbled across this document while trying to determine my own needs for which ATF I needed for my truck after reading that some owner manuals had the wrong information in them.
Anyway hope this helps someone.
MotorCraft ATF Chart
I stumbled across this document while trying to determine my own needs for which ATF I needed for my truck after reading that some owner manuals had the wrong information in them.
Anyway hope this helps someone.
MotorCraft ATF Chart
The following 2 users liked this post by jc4spam:
17Sport4x4 (06-30-2022),
Lare (03-25-2021)
#29
Senior Member
I'm just thinking that the Ford parts counter (You can even call them) should know the correct pan gasket and fluid stock numbers.
I had mine changed by a Ford tech at about 33K miles and again a few months ago by a dealer when he replaced the lead frame.
I had mine changed by a Ford tech at about 33K miles and again a few months ago by a dealer when he replaced the lead frame.
The following users liked this post:
jc4spam (03-18-2021)
#30
Senior Member
This is the 10 speed
Last edited by Bluewoo; 03-18-2021 at 07:46 PM.
The following 2 users liked this post by Bluewoo:
jc4spam (03-18-2021),
Mitch Lewis (12-13-2022)