What Mods/Changes Have You Done To Your 2015 or 2016???
04-07-2015, 09:37 PM
#91
Senior Member
Thread Starter
Two thumbs up to this mod 
Thanks Bikermike, I followed this link and bought my on Amazon. Makes the screen in my plat look like glass, and no more visible prints. Easy install, did it myself. I cleaned screen well with a light touch of ammonia free glass cleaner (directions said don't use anything), made sure screen was 100% dry and as free of dust as I could get it, put on the included finger condoms to keep prints off, and laid the screen protector over existing screen. I Used a credit card to smooth out edges. love the look... truly looks like a glass screen now.
Thank you BikerMike for sharing!
Thanks Bikermike, I followed this link and bought my on Amazon. Makes the screen in my plat look like glass, and no more visible prints. Easy install, did it myself. I cleaned screen well with a light touch of ammonia free glass cleaner (directions said don't use anything), made sure screen was 100% dry and as free of dust as I could get it, put on the included finger condoms to keep prints off, and laid the screen protector over existing screen. I Used a credit card to smooth out edges. love the look... truly looks like a glass screen now.
Thank you BikerMike for sharing!
I didn't think this mod would be that much appreciated by me but the more I'm in the truck the more I'm glad I did it!
Bob
04-08-2015, 11:09 AM
#92
Senior Member
Got a 2015 XLT Sport. You can find more pics of it here:
https://www.f150forum.com/f118/xlt-s...gnetic-294586/
Haven't done a ton to it yet, but here's what I have done so far:
Got Katzkin leather installed. Ordered through my dealer.
Took the Sport decals off. If it was FX2 I'd probably keep it, but I don't like the Sport. They came off super easy. No hair dryer, just my hands. Zero residue.
Installed the Stubby antenna. It's very short, 3".
Installed the same LED fogs found in this thread. Hard to tell in daylight pics, but they are very white. Also installed Silver Star Ultras in the high and low beams.
https://www.f150forum.com/f118/xlt-s...gnetic-294586/
Haven't done a ton to it yet, but here's what I have done so far:
Got Katzkin leather installed. Ordered through my dealer.
Took the Sport decals off. If it was FX2 I'd probably keep it, but I don't like the Sport. They came off super easy. No hair dryer, just my hands. Zero residue.
Installed the Stubby antenna. It's very short, 3".
Installed the same LED fogs found in this thread. Hard to tell in daylight pics, but they are very white. Also installed Silver Star Ultras in the high and low beams.
Last edited by AClayeJ; 04-08-2015 at 11:11 AM.
04-09-2015, 05:49 PM
#93
Senior Member
Thread Starter
Has anyone removed the rear block on a 4X4 to level the truck rather than raising the front end???
I was looking at the rear leave spings and see there is about a 2 inch block under them. Wondering how hard or easy that would be to just remove and clamp it back down without it to level the truck more.
Bob
I was looking at the rear leave spings and see there is about a 2 inch block under them. Wondering how hard or easy that would be to just remove and clamp it back down without it to level the truck more.
Bob
The following users liked this post:
cornwoman (01-18-2017)
04-10-2015, 11:02 PM
#97
Has anyone removed the rear block on a 4X4 to level the truck rather than raising the front end???
I was looking at the rear leave spings and see there is about a 2 inch block under them. Wondering how hard or easy that would be to just remove and clamp it back down without it to level the truck more.
Bob
I was looking at the rear leave spings and see there is about a 2 inch block under them. Wondering how hard or easy that would be to just remove and clamp it back down without it to level the truck more.
Bob
04-11-2015, 07:20 PM
#98
Senior Member
Got these off Amazon:
https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1
Like you, I ordered the TrueVue Crystal Clear screen saver that bikermike recommended. I hate all those fingerprints!! .........
https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1
Like you, I ordered the TrueVue Crystal Clear screen saver that bikermike recommended. I hate all those fingerprints!! .........
. I got them out ok and the new lamps in the sockets, but getting them to snap into place ...... Ouch! The driver side was easier, but the passenger side took me forever.i finally (of course you have to remove the two liner screws) was to go under the steel cross member instead of over. It was a great inexpensive mod (~$25 delivered) The color and brightness is vastly improved. I also got the Lexerd screen saver that Bikermike put us onto.
mods now:
Ford wheel well liners
Ford molded mud flaps
ARE LSII Tonneau
Lexerd screen saver for 8" center display
Lloyd Luxe custom carpet mats embroidered with 2015 F150 logo.
LED fog lights
Line-X spray in bed liner
Some Ole Miss custom wallpapers for center screen
Carid stainless steel tag frame
Last edited by mallen4258; 04-11-2015 at 07:34 PM.
04-11-2015, 08:29 PM
#99
Senior Member
Thanks again for the link for the fog light mod! Got it done. What led license plate bulb did you go with?
04-11-2015, 10:24 PM
#100
Senior Member
Thanks MarineLDO for the link. I got my LED Fog lamps in the mail today and got them installed. I know some said it was easy, they just did not have the size of ham fists that I have . I got them out ok and the new lamps in the sockets, but getting them to snap into place ...... Ouch! The driver side was easier, but the passenger side took me forever.i finally (of course you have to remove the two liner screws) was to go under the steel cross member instead of over. It was a great inexpensive mod (~$25 delivered) The color and brightness is vastly improved.
. I got them out ok and the new lamps in the sockets, but getting them to snap into place ...... Ouch! The driver side was easier, but the passenger side took me forever.i finally (of course you have to remove the two liner screws) was to go under the steel cross member instead of over. It was a great inexpensive mod (~$25 delivered) The color and brightness is vastly improved.
The following users liked this post:
msabryan (09-01-2015)