What did you do to your truck today? Reboot.
#8721
WD 40 will clear it
The following 4 users liked this post by 03screwon22's:
The following users liked this post:
SportScout (05-03-2024)
#8724
Junior Member
I added four BULL RING tie downs to the bed stake openings so I have more points for securing cargo.
Also, I recently picked up a used hitch cargo carrier that doubles as a bicycle carrier. It is 30 inches wide, so I could use it for transporting a lawn mower or snowblower if needed. I'm adding some red running lights for safety. I should be finishing up the wiring later today.
Also, I recently picked up a used hitch cargo carrier that doubles as a bicycle carrier. It is 30 inches wide, so I could use it for transporting a lawn mower or snowblower if needed. I'm adding some red running lights for safety. I should be finishing up the wiring later today.
Last edited by PeterTheFirst; 05-02-2024 at 02:35 PM. Reason: details
The following 6 users liked this post by PeterTheFirst:
artsr2002 (05-02-2024),
foxx4afoxx (05-02-2024),
gwise06 (05-03-2024),
KennyCJR (05-02-2024),
roxynoodle (05-03-2024),
and 1 others liked this post.
#8725
TOTM April 2024
Not sure I should put this here, new thread, or couldn't find a specific thread:
Removed the "Sport" decals off my XLT. Used heat gun, etc.- but one side still has that "shadow"/residue while the other side came out great without any problems.
Any suggestions for removal? Goo Gone, Nail Polish Remover used lightly did not work.
I don't want to use a rubber erasers then polish/wax.
Removed the "Sport" decals off my XLT. Used heat gun, etc.- but one side still has that "shadow"/residue while the other side came out great without any problems.
Any suggestions for removal? Goo Gone, Nail Polish Remover used lightly did not work.
I don't want to use a rubber erasers then polish/wax.
#8726
Washed it, added wiper fluid (still ticked they took the fluid level sensor/light away on the 16s), and changed my air filter.
The following 2 users liked this post by KingBeef:
foxx4afoxx (05-02-2024),
TW Squirt (05-02-2024)
The following 4 users liked this post by Blakeusmaximus:
#8729
Senior Member
Today my dealer replaced the rear driveshaft…again ! Vibrations, humming. I lost the count, I think this is the fifth time…Back to smooth ride, but for how much time..?!
The following users liked this post:
foxx4afoxx (05-03-2024)
#8730
Senior Member
Started it up to leave work and thought "that's quite a bit louder than normal" but i had just changed the tune so thought maybe it's just a weird e85 cold start. Go to drive away and nope it sounds straight piped. Damn muffler pipe slipped off my resonator and my Tremor tailpipes popped out of their hangars. The way it's setup right now the resonator pipe probably needs shortened a bit so I can push everything forward, about an inch. Fortunately the tips have hangars and kept everything hanging so I could get home before worrying about. I don't how many hear have driven a truck with longtubes and no muffler but...it's horrendous. Particularly in the cab
The following users liked this post:
foxx4afoxx (05-03-2024)