Picked up a used Tyger T1 roll up for $120. Its practically brand new. I think I installed it correctly and tightened down the clamps enough. Nervous about it flying off. I think I need to tighten it left to right a little bit? Does this look right to everyone? Notice some creases/wrinkles on the right hand side.

 

Looks like mine. Just unzip the velcro on the pass side and stretch it on and park it in the sun.

 

Thanks does your velcro on the cover matchup perfectly with the velcro on the rails? My cover velcro overlas pass the rail velcro a bit it doesn't fit right on top 100% is that fine?

 

I have a Tyger and yes the Velcro does overlap. Like Jag said, I unroll all the way then run my finger under the Velcro to insure it's unhooked. Then engage the locks and slam down the corners. On each side pull up and out then press down on the Velcro, each end and near the middle. If done properly you'll only see the braces. They stretch over time so you may have to loosen and move the fixed locking tabs. I think you'll like the cover. I took a trip from NC to NY and back a few months ago, through several rainstorms and have yet to see any water in the bed.