bdresch

iTrader: (1)

I知 working on completing the 360 camera wiring. Every connection so far I have been able to do just by adding pins, but now I need to do the CAN HS connection.
1. Can I just tee splice into and CAN HS low and high wires?
2. I知 not going to finish all the wiring in one shot, can I tee into the CAN and connect the other end to a module and be okay without the module powered up? I can leave the splice until I知 ready with everything, but I致e got the dash tore apart now and would rather not pull it apart again if I can do this connection now.

antho

See if you have a small harness attached to the panel where the pre collision alert light is. I made a harness that plugged in there. Has bus and ground if I remember correctly. Keeps from splicing. If you have it anyway.

bdresch

iTrader: (1)

I don稚 have precolision so not sure where that is. I壇 rather not splice for sure if there is anything nearby. My wires are already run to the brake controller location but I could move them.