P0106 Code
Thread Starter
Junior Member
Joined: Feb 2026
Posts: 10
Likes: 0
P0106 Code
I changed my MAP sensor on the back of the intake manifold and now I am getting a P0106 code. It wasn't there when I started, but now it will not go away.
I started to clean the sensor and the plastic nipple broke off into the intake manifold. I was able to get it out by removing the intake and replacing the gasket, but now I cannot get rid of the P0106 code. Any suggestions?
I started to clean the sensor and the plastic nipple broke off into the intake manifold. I was able to get it out by removing the intake and replacing the gasket, but now I cannot get rid of the P0106 code. Any suggestions?
5 Year Member
Joined: May 2018
Posts: 2,448
Likes: 847
From: Southeast PA
Did you seal up the sensor bung good and tight? Any hoses left off or wires broken?
"Code P0106 is an OBD-II generic code indicating a "Manifold Absolute Pressure (MAP) or Barometric Pressure Sensor Range/Performance Problem." It means the engine control computer detects an implausible pressure reading from the intake manifold compared to current engine load or throttle position. [1, 2,
]"
"Code P0106 is an OBD-II generic code indicating a "Manifold Absolute Pressure (MAP) or Barometric Pressure Sensor Range/Performance Problem." It means the engine control computer detects an implausible pressure reading from the intake manifold compared to current engine load or throttle position. [1, 2,