Just did front brakes. Knew I had the evap, small leak code (used to be very small leak). Went for a drive to seat the brakes and ran the scanner. I know it says tesr not complete but I don't recall ever seeing all the codes when the cycling hasn't completed. This normal?

truck runs fine.

 

Are you asking if the codes are normal or if its normal that the test is not complete?

 

If you're chasing an issue, clear the codes and see what comes back. I have a hard time believing those are all valid.

 

Yep or maybe a bad battery, low voltage.

 

Sort of wondering if seeing all these pop up is normal since I've never seen this many, ever, while using this product. I use in a ford focus, f150, and accord.

I cleared it and it shows much much more but the test message was a little differernt. This scan was a few minutes after clearing and either check engine light gone.

Battery is good, replaced less than a year ago but I'll check the voltage tomorrow.