I am trying to install some husky wheel well liners and I was going to use the holes that are already in the back of the wheel well to attach the liner with. I was planning on using a bolt nut and some washers. Will me using a bolt and it possibly rubbing the back side of the wheel well cause it to rust? How are you guys installing these liners?

 

You should avoid using a steel bolt that will contact the aluminum. It will make the aluminum corrode. I would think there should be proper hardware included. I haven't installed them, so I don't know for sure

 

supplied hardware

 

My Husky liners came with the proper fasteners to install. Very simple install.

 

I had a 14 so I was trying to reuse them they are the same ones I just don't have the hardware for a 15 I have the stuff for a 14

 

Are those black screws? I have four of those with the clips but didn't know if those would work

 

they work great

 

Does anybody know if my 14 liners will work with the 15 truck?

 

I'll state the obvious. Don't ask people on a forum, call Husky.

https://www.huskyliners.com/contact-husky-liners

They will tell you a) if the liners will fit and b) if they can send you hardware since the 2015 / 2016 liners need different hardware to attach to an aluminum body.

 

That would have been great info to include in your original post