I recently flashed the truck for global open/close, bambi, navi screen GT performance, no seatbelt chimes. Everything is working correctly EXCEPT in the morning when I use my remote to warm up the truck. I unlock the truck and get in, put the key in the ignition to on, and the cluster AND sync3 screen is BLANK.

Once I drive about 2 mins the cluster and screen comes back on.

Should I just reprogram everything back to stock? 2018 F150 XLT.

Thank you in advance.

 

Asking on the ForSCAN sticky will get you better and quicker responses.

 

Double check you got all the values right for your changes. Then undo one at a time to see which one it was.

 

When I remote start my truck, the screen is blank. It doesn't start up until the key is turned on. I don't think it takes two minutes though.
But it may have something to do with the GT screen, I can't remember if I have my screen set for that. The rest of what you changed should not make a difference.

 

I had a similar issue when I tried to change the CDN headlights to be off, when I undid that change it never happened again.

 

Last time I made a bunch of changes, when I started the truck the next day, blank screen, after about a minute and a half, it said it was performing updates, been fine for the last 2 weeks, mine is sync 2 though.....

 

Thanks for the help everyone. Still trying to figure it out.

 

Put your radio splash screen back to normal and see what happens!!

 

Will do

 

Is this to open and close all doors at the same time with the remote? I changed that setting in the dash without ForScan.