Hi,I installed the shock sensor and the overhead motion sensors to my 2020 xlt all the parts installed good and the forscan programming seems good the whole alarm system works good but the menu in my advanced settings is not there so I can’t turn The motion sensors off. I’ve been looking for about a month and a half for a way to add the alarm menu to the dash but I have come up empty. Is there a way to program it with forscan or do I have to have the dealer do it? Any help would be appreciated.
PS. The motion sensors are brand new from the Ford dealer and seemed program without any errors and do since motion.

 

The Alarm Menu showing on the IPC has to do with the setting of 720-02-02 *xxx xxxx xxxx controls the Settings>Advanced>Vehicle menu where * is a follows:

0 = Alarm Menu - Absent
1 = Rear Parking Aid Menu - Present
4 = Alarm Menu - Present
5 = Alarm Menu - Present, Rear Parking Aid Menu - Present

Unfortunately I do not know any more of the settings for this byte but this should give you a starting point. I'm not sure if these only work for the 8" display.

 

FORScan Changes:

• IPC
720-02-02-5xxx-xx

• BCM
726-02-01-xxxx-x1xx-xxxx
726-34-01-x1xx-xxxx-xxxx
726-39-02-x1xx-xxxx-xxxx

From this thread: https://www.f150forum.com/f118/2015-...trofit-416887/

 

Thank you both, the thread suggested is the one that I followed to install them and follow it step-by-step. so I’ll go in and double check did everything Took

 

I followed that same thread and have the options in my IPC, although it’s the 8”. I’m pretty sure the AsBuilt is the same for the 4” IPC though.

You might want to try an IPC reset procedure in Forscan to force the module reset.