Depends who you buy them from.... Ebay and CTS are expensive for what you get.

Lol This guy right here... Hope things are going good Mike. Wish I had a paint guy like you in my neighborhood.

 

All I know is if mbullock is gonna do some emblems I need to know where that line starts cause I've seen your work and is boss. Let me know.

 

Mike, you know damn well, I wasn't referring to you!

 

Haha! Yeah, I couldn't resist

 

these guys have some good stuff. I had some on my old jeep, looking to do a custom pair with them on my new f150 ( pretty sure theyll make anything you want)

http://www.maineventemblems.com/

 

Cool, I haven't seen that site before.

 

They are a real bitch. I wish someone would make a simple, clean looking badge without the trim level.

 

I was just about to tell you the holes are 7 3/4" apart, at the widest point. They are also just under 1" tall.

 

When I removed mine, I used fishing line to go under the emblem as much as possible (until you hit the clip). Then I would also go from the top with the fishing line under each of the F150 characters. Once I got to that point, I raised my hood and pressed the clip together with my fingers as I slowly pulled from the same side. After the clip came through, I put the fishing line on the other side of the clip until I hit the alignment pin. Then went around the alignment pin and worked my way to the other alignment pin.

It really wasn't that bad. Just takes a little patience and 10 minutes of work per side.