Hi guys

I was having this errors with hill assist and similar errors, replaced throttle body, all was good and now I got this other error in my way back from nc to fl. Twice already.

any pointers where to check? Maybe a loose connector?

thank you


===PCM DTC ===
Successful DTC reading, no error codes found

Module: Powertrain Control Module
===END PCM===

===OBDII DTC ===
Successful DTC reading, no error codes found

Module: On Board Diagnostic II
===END OBDII===

===APIM DTC ===
Successful DTC reading, no error codes found

Module: Accessory Protocol Interface Module
===END APIM===

===PAM DTC U0131:00-28===
Code: U0131 - Lost Communication With Power Steering Control Module 'A'

Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC

Module: Parking Aid Module
===END PAM===

===BdyCM DTC U0131:87-08===
Code: U0131 - Lost Communication With Power Steering Control Module 'A'

Additional Fault Symptom:
- Missing Message

Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC

Module: Body Control Module
===END BdyCM===

===APIM DTC ===
Successful DTC reading, no error codes found

Module: Accessory Protocol Interface Module
===END APIM===

 

I would start by checking for any wire damage near the connector that attaches to the EPAS unit. There has been a few reports of rodent damage in this area.