The 2015's and up are hard, not a lot of good places because there are THINGS behind the panels. Here is where I'm putting 3 of mine, this is the opening so far for 3 rockers:



The cut-outs for the switches (switches arrive Thursday)




The cut-outs for the switches (switches arrive Thursday)

 

I am planning to install 4 of these in the vertical space above the center console.
I am going to paint them to match the gray plastic.

https://www.amazon.ca/gp/aw/d/B013ET...WML&ref=plSrch

This is what I am using for inspiration.

http://www.f150ecoboost.net/forum/55...tch-panel.html

 

The page that I took the picture from said it was the 2017 raptor.

 

Exactly, don't see why that console wouldn't work. If that isn't feasible I'll most likely fit the superduty switches somewhere kinda like this

 

wow I like that a lot. i wonder if there is enough room to fit that switch panel between the 4wd switch and the trailer brake control like was done here.

 

@4x4:

I like that look and position a lot. Was there not room to do it under the 4 wheel control on the driver side?

 

[/QUOTE]

Damn I like this look a lot! Is there anywhere to buy this setup yet?

 

I am going to take a guess that we don't have any pass-through wires such as the raptors do do we? What I'm talking about can be seen in this thread about wiring up the aux switches in a ford raptor. Looks so easy even i can do it! Unfortunately I don't believe we are this luck.

http://www.fordraptorforum.com/f170/...witches-20335/

 

Damn I like this look a lot! Is there anywhere to buy this setup yet?[/QUOTE]

as this is from the 2017 F250 its doubtful that you'll be able to buy the parts for a while yet

 

Looks like you'll have to fabricate that yourself. But it is nice. I'd even do this on my truck if someone could fabricate it for me...