Just did a zf5 swap in my 95 f250 5.8 have everything I need but the wiring it won't start and I no why I jut need to no if the trans wiring from a 95 f150 with a 4.9 m50d tranny will work ?

 

Are you talking about the neutral safety? The wring should all be the same, the key ignition power just needs to reach to starter relay.

 

where ur e40d plug for ur gear selector is it wont start unless you have it hooked up or if you put a standard harness on it i have one but its from a 300 6 with a m50d i just wanna make sure it will work and will the pcm from the 300 fit the 5.8??

 

No the PCM from a 300 won't work on a 351. I doubt the harness will plug into you're truck so you would need to splice in the wiring and make the neutral safety work in the E4Od harness.

 

i just put the harness on it plugged in and i havent tried to start it yet but i can hear my starter solenoid kick in but my batter is rly dead the plug i put on has a jumper wire that goes fom one back into the pl;ug into another spot is that for the neutral safety?