I just completed an E4OD replacement and I cant find where this bracket bolts to it carried the fuel lines as they transitioned from the frame to the side of bellhousing and up to the back of 5.8L and of course I didnt take enough pictures





The arrows point out two large 1/2 holes but the spacing does not line up with bellhousing bolts.... the hook is where the fuel lines ran through and the tab with three holes I am sure is for wire loom push in holders. If anyone will take a look under their 1989-1995 chassis close to drivers side bellhousing at frame level I would really appreciate the help

 

Its been awhile since i have turned a wrench on that yr.

But my memory seem to think it goes up by the cyl. head.
Try looking for your downstream O2 sensors and where the loom clips are..... that might help locate the spot better. (or the other harnesses that run thru there)

 

You are correct phil right up there in no mans land Thank You.

 

Your welcome , glad to help.