Should be doing a tune up on my truck this weekend. Going for spark plugs spark plug wires, distributor cap, fuel filter, top off all my fluids or change, and I'm going to cut my rotors buy new pads, regrease my wheel bearings unless they need to be replaced including seals. and cut drums and buy shoes, is there anything I'm forgetting?

 

no sir.. just gap plugs correctly, I run motercraft copper plugs and motorcraft wires and Standard Motor Products cap and rotor. Might as well grease all your bushings and u-joints while you're at it.

 

Well I need to just replace my plugs, they have about 20k on them and the truck sat for 3 years and I can tell I think I have a misfire.and how would I grease my u joints? Take them out and grease the little caps where the neddle beatrings are?

 

It's been forever since I even bothered with Ujoints, but last I knew they had Grease Fittings on them.

 

Never knew that lol thanks man

 

Some do. Some don't.

 

Well looks like ima have to check